Guys I wanted to share some info with you about finn triggers and a mod I did to my trigger to lower the lbs of the pull. So I have been shooting my suppressed 28/76 long range and have noticed that the trigger is still a little heavy for my liking. It is very crisp in the second stage, but heavy. So I removed the action from the stock and worked the trigger to see right where the sear spring has the most movement. I then removed the sear spring and using a Dremel, with a fine grinding stone, I began to lightly grind away material very little at a time. I ground a small amount on both sides and tested very often for function, in between the light grinding. When I got to where I really liked it I stopped and inspected the sear spring. I barely removed any material, but the lbs change dramatically. From what I could tell I only went deep enough to smoothen out the machine marks left on the steel. Hope this helps some of you, just remember to remove very very little between safety checks!